Phelma Formation 2022

EU Introduction to characterization, electrochemistry and chemical engineering - 4PUPICEP

  • Number of hours

    • Lectures 0
    • Projects 0
    • Tutorials 0
    • Internship 0
    • Laboratory works 44.0
    • Written tests 0

    ECTS

    ECTS 4.0

Goal(s)

To provide students with the basic concepts of chemical analysis, electrochemistry and unit operations, while immediately tackling the experimental aspects of these disciplines.
For the "Unit operations" section, the emphasis is on practical approaches to unit operations issues:
discover an installation, carry out relevant measurements and observe transport, transfer, system dynamics and fluid mechanics phenomena.

Contact Lenka SVECOVA

Content(s)

1) Projet analytique

Introduction : analyse chimique : identifier les composés présents dans un milieu et/ou leur quantité respective.
Les TP permettent d'appréhender les thématiques suivantes :

Nécessité d'une étape de séparation ou non avant l'analyse (ex : chromatographie ionique, absorption atomique)
Dosage d'un composé à l'état de trace ou massif (ex. dosage de traces de cations alcalins dans l'eau, composition d'un composé binaire)
Principe physique de la mesure quantitative : gravimétrique (ATG, ATD), optique (absorption/émission, longueur d'onde), électrochimique (ex : conductimétrique, potentiométrique, faradique, capacitive)
Précision, étalonnage, gamme de sensibilité
Les milieux analysés eux-mêmes seront variés (au moins un milieu solide et une solution aqueuse).

2) Electrochimie

3) Génie de procédés



Prerequisites

Basic knowledge of matter transfer and balance (conservation of matter), electrochemistry and analytical chemistry

Test



Additional Information

This course brings 3.0 ECTS to students in Engineer APPRENTISSAGE MEP 2Y

Course list
Curriculum->Apprentissage MEP->Semester 7
Curriculum->EPEE->Semester 7
Curriculum->Master->Semester 7